I am using Hyena 5.7 with RCM v1.11 with the tightvnc.tcm and tightvnc.bat files listed in an earlier post. I am able to install to a remote machine, and when i select view the service starts just fine, but I always get "authentication failed" when prompted for a password. When I install, in the 2 blanks where you can enter a password, I enter "vnc", and try the same thing when the service starts and I am prompted for a password, but authentication always fails. I am copying my .rcm file below....any ideas? Thanks in advance!

[General]
SoftwareType=VNC
Enabled=1
MenuName=tightVNC
AutoExecute=0

[View]
ViewerCommand="c:\Program Files\Hyena\tightvnc.bat" %computer%
StartServiceBeforeViewing=1
StopServiceAfterViewing=1
AutoInstallBeforeViewing=0
UnInstallAfterViewing=0
AutoTerminateAfterViewing=0

[Install]
EULA=
SourceDirectory=C:\Program Files\TightVNC
DestinationDirectory=\\%computer%\admin$\system32\ rc
FileList=winvnc.exe;vnchooks.dll
InstallService=1
ServiceNames=TightVNC
ServiceAutoStart=0
ServiceDisplayName=TightVNC
ServiceExeName=winvnc.exe

[VNC Options]
InstallServiceHelper=1

[VNC Settings]
Password=
PasswordViewOnly=
QuerySetting=2
QueryTimeout=10
QueryAccept=0
QueryAllowNoPass=0
SocketConnect=1
AutoPortSelect=0
PortNumber=5900
HTTPPortNumber=5800
InputsEnabled=1
LocalInputsDisabled=0
IdleTimeout=0
LockSetting=0
RemoveWallpaper=1
PollUnderCursor=0
PollForeground=1
PollFullScreen=0
OnlyPollConsole=1
OnlyPollOnEvent=0